19
VOLTAGE BALANCING AND MONITO RING IN THE DISC HARGE PROCESS
The processor monitors voltage of each cell when the battery packs are during its “storage” and
“discharging” process. to achieve this feature, plug each battery to the charger individually. If
voltage of any cell is abnormal, RC-6S will show error message and terminate the program
forcibly. So if there is battery damage or disconnection, you can see the error message and press
INC to know which cell is damaged.
NIMH CHARGE Aut
CUR LIMIT 5.0A
D E C
I N C
D E C
I N C
Batt Type
Stop
Start
Enter
‘>3 seconds’
R:3SER S:3SER
CONFIRMC(ENTER)
NIMH 2.0A 7.42V
CHG 022:45 00890
Number
of cells
Elapsed
time
Supplied
capacity
Charged
Voltage
battery
Charging
current
BATTERY VOL ERR
CELL LOW VOL
4.14 4.16 4.09
2.18 0.00 0.00
I N C
The
processor
detects
voltage
of
one
cell
is
too
low
.
The
4
th
cell
was
damaged. The value of voltage may be zero if
disconnection occurs.
Charging of NiCd /NiM H battery
This program is for charging and discharging of NiCd/NiMH batteries
associated with R/C models applications. You can press
START/ENTER key to make it blink and then INC or DEC to change the
parameter value. Press START/ENTER key to store the value.
This program is for charging the battery using the current you set up. In
the “auto” state, you should set up the upper limit of the charge current
to avoid damage by excessive feeding current. Some batteries of low
resistance and capacity can lead to higher current in the “auto”
charging mode. But in the manual mode, it will charge with the current
you set. You can make it blink in the current filed and press INC and
DEC at the same time to switch mode.
VOLTAGE BALANC ING AND MONITO RING IN THE DISCHA RGE PROCESS
