11
Remove the Screws, and separate Canopy as shown.
如圖所示拆除螺絲並分開罩蓋。
Take the Canopy (2 pieces) and place towards Hanger Plate Assembly as shown. (Canopy fi xing direction follow to
diagram as shown below.)
取罩蓋(
2
片)並如圖所示朝吊板組件放置。(請遵循下圖所示的罩蓋安裝方向。)
Canopy /
罩蓋
Screw /
螺絲
Press /
按
Remove the Screws /
拆開螺絲
Pull /
拉
Install Canopy to Motor Assembly /
安裝罩蓋至發動機組件
E)
2
2
1
1
Make sure Canopy is installed above Hanger Plate Assembly and clipped until the “click” sound is heard.
確定罩蓋被安裝在吊板組件之上並夾住直至聽到“喀噠"聲。
Make sure Canopy installation follow as diagram shown. /
務必遵循圖示安裝罩蓋。
Can cause Canopy damage after screw fi xing. /
鎖上螺絲後會導致罩蓋損壞。
NOTE /
備註
Canopy /
罩蓋
Click /
喀噠
< Top View - For Viewing Purpose Only > / <
頂視圖 - 只供參考
>
Hanger Plate Assembly /
吊板組件
Canopy /
罩蓋
Concrete Ceiling /
混凝土天花板
Concrete Ceiling /
混凝土天花板
M11SU(REVISION)_EN-CT.indd 11
M11SU(REVISION)_EN-CT.indd 11
12/14/2010 12:40:07 PM
12/14/2010 12:40:07 PM