
14
+
CR2
032
3V
安裝 方 法
HOW TO INSTALL
初次 使 用前 請 去除膠 紙
。
(
按 電池更 換 方法
,
取 下電池 蓋 后
,
去除 膠 紙
,
不 用取下 電 池
。
)
電池更換方法
(
使用
CR2032
型號電池
。
)
更換電池
安裝電池蓋
將電池蓋放入遙控器中
,
再按壓電池
蓋中間位置
,
并聽到
“
滴答
”
一聲
。
將電池
向上放入電池
固定位
。
膠 紙
丟 棄電池 時
,
請遵循 當 地法律 法 規
。
用一 字 螺絲刀 在 凹槽往 上
撬開 電 池蓋
。
一 字螺絲 刀
凹槽
電 池 蓋
Please remove the adhesive tape before using the remote control for the first time.
(According to the method for replacing the battery, after removing the battery cover,
remove the adhesive tape without removing the battery.)
警告
WARNING
禁 止將 電 池 放置 在 嬰 幼兒 可觸 及
到 的 地 方
。
萬一錯 誤 吞食
,
請 從速求 診
。
Do not put the battery in reach
of children and infants.
If the battery is swallowed,
seek medical help immediately.
禁 止 將電 池 投 入 火 中及 加熱
、
分 解
、
改 造
。
如 損傷了 絕 緣物或 排 氣閥等
,
可能會 導 致
電 池發熱
、
破裂
。
Do not put battery into fire or heat,
break, modify it.
If the insulation or exhaust value is
damaged, the battery may become
hot, crack.
Adhesive tape
Flat-head
screwdriver
Install the battery cover.
Put the battery cover into the
remote control, and then
press on the middle position
of the battery cover until a
"click" is heard.
Replace the battery.
Put the battery into
place with facing
upward.
Pry the battery cover up
in the groove using a
flat-head screwdriver.
Groove
Battery
cover
How to replace the battery (when a CR2032 battery is used.)
5.Please comply with local laws and regulations when dispose the battery.
試運 轉
TEST RUN
扇 葉是否 正 常旋轉
?
是 否有不 正 常的震 動 或者噪 音
?
※
安 裝 完成后
,
接通電 源
,
遙控 器 對碼 後 按 動各個 功 能按鈕
,
檢查以 下 項目
:
※
After the installation, turn on the power supply, pair the remote control with the
product, and then press functional buttons to check the following items:
Does the fan revolve normally?
Does it have abnormal vibration or noise?
提示 事項
Notice
長期 不 使用時
,
請取出 電池
。
更 換電池 時
,
請擦 乾 遙控器 機 體後進 行 更換
。
2.Do not replace the batteries when the remote control body is wet.
1.lf you will not use the remote control for a period of time, take out the batteries.
請 勿將遙 控 器浸入 水中
。
拿取遙 控 器時請 小 心
,
以 免 遙控器 掉 落導致 損 壞
。
3.Please be careful with picking up remote control, to avoid dropping and cause damage.
4.Please don't immerge the remote control into water.