36
NOTE
The number and type of cables may vary from model to model.
Both ends of the cable are different, so make sure the cable end is correct before binding the pipes.
The binding shall be seamless and neat in appearance.
4
Install sealant and wall hole sleeve cover.
①
Arrange the WRaPPed pipes.
①
Apply the sealant to the gap between the pipe and wall and press it tightly.
①
Pull open the wall hole sleeve cover, and insert the pipe through the hole
until it is pressed against the wall.
5
Water Drainage Test
Drainage
①
Open the louver.
①
Fill the fins of the heat exchanger with water.
①
After confirming that the drainage is smooth
and free of water leakage, install the filter and
close the panel assembly.
Make sure that no
water is splashed.
