18
Recommended Installation Sites
It is recommended to install the air conditioner according to the design drawing of the HVAC engineer. The
selection principle for the installation site is as follows:
Ensure that the airflow in and out of the indoor unit is reasonably organized to form an air circulation in the room.
Prevent the air conditioner from blowing directly at the human body.
Keep the air-conditioning return air away from direct exposure to the sun in the room.
The indoor unit should not be lifted in the places like load-bearing beams and columns that affect the structural safety
of the house.
The wired controller and the indoor unit should be in the same installation space, otherwise, the sampling point
setting of the wired controller needs to be changed.
Choose a site that fully complies with the following conditions and user requirements to install the
air conditioning unit:
There is enough space for installation and maintenance.
The ceiling is level, and the structure is strong enough to support the indoor unit. If necessary, take measures to
reinforce the unit's stability.
Airflow in/out of the unit is not obstructed.
It is easy to supply airflow to every corner of the room.
It is easy to drain for water drain piping.
There is no direct heat radiation.
Avoid installation in narrow spaces or where there are more stringent noise requirements.
Install the indoor unit at a place 2.5m above ground.
The length of the piping between the indoor and outdoor units is within the permitted range. Refer to the Installation
and Operation Manual attached with the outdoor unit.
＞
100mm
＞
100mm
Air return
Air outlet
Louver
≥100m
m
≥100mm
≥100
mm
Installation distance from both sides of
the indoor unit to the wall
Installation distance from the top and
back of the indoor unit to the wall
Installation distance from the back
of the indoor unit to the wall
Ceiling&Floor
Ceiling
Floor
WARNING
Install the air conditioner in a location with sufficient strength to support the weight of the unit. Take reinforcement
measures when neCeSSaRy.
The unit may fall and cause personal injury if the location is not strong enough or if the air conditioner is not properly
installed.
Before wiring/pipe layout, make sure that the installation area (walls and floor) is safe and free of water, power, gas,
and other hidden dangers.
The unit needs to be level and shall not tilt to either side or forward.
