Kayoba 022176, Руководство по эксплуатации, Страница: 25 / 52

25
2023_001
3.4.1 To fit the right pedal
1
Turn the pedal clockwise on the chain side of the
crank arm.
2
Tighten the bolt with a 15 mm combination spanner
(Figure 9).
3.4.2 To fit the left pedal
1
Turn the pedal counterclockwise, on the opposite
side of the chain side of the crank arm.
2
Tighten the bolt with a 15 mm combination spanner
(Figure 10).
3.5 To install the saddle post and the
saddle
1
Put grease on the saddle post.
2
Install the saddle post into the seat tube.
Note! Make sure that the marking for the top postition on
the saddle is below the edge of the seat tube.
3
Lock the saddle post to the required height and
tighten the bolt (Figure 6).
4 Operation
4.1 To do before the operation
● Make sure that the saddle and the handlebars are
adjusted correctly (Figure 8).
● Make sure that the product is assembled with brakes and
a bell.
● Make sure that the product has a front lamp with a white
light and a rear lamp with a red light. Make sure that the
lamps can be lit.
● Do a check that the reflectors of the product are correctly
installed, clean and not obscured. Replace damaged
reflectors.
● Learn how to use the components and accessories on
the product correctly. If you do not learn how to use the
brakes on the product you can get seriously injured.
● Make sure that the brakes stop the wheels when applied.
● Make sure that the brake pads are not worn out.
● Make sure that all screw and components are tightened
and correctly installed.
● Make sure that the wheels are correctly installed.
● Make sure that the rims are not damaged.
● Make sure that the tires are not damaged. Make sure that
the tires have the correct air pressure.
● Make sure that the steering moves correctly.
4.1.1 To adjust the saddle’s postion
1
Loosen the bolt under the saddle (A) and move the
saddle to desired position. Move the saddle with
small adjustments to find the correct position. (Figure
7)
Note! If you have you foot on the pedal with the crank arm
horizontal, the pedal should stay vertical below the knee.
2
If it is necessary, adjust the angle of the saddle.
Tighten all nuts and bolts.
4.1.2 To adjust the height of the saddle
1
Loosen the bolt holding the saddle post and adjust
the height of the saddle (B). Tighten the bolt.
Note! Make sure that the marking for the top position on the
saddle is below the edge of the seat tube.
4.2 The brake
Warning! Do not use a product with brakes that do
not work correctly.
● The product has a rim brake at the front and rear. There is
a brake lever on the left side of the handlebars that
applies to the front brake and on the right side for the
rear brake.
4.2.1 To use the brakes
● Apply the rear brake before you apply the front brake.
Warning! Do not apply the front brake when you turn
the product or on a slippery surface.
5 Maintenance
To make sure that the product is safe to use, only use
original spare parts when you replace parts that are
applicable for safety.
● Let an approved service center do service to the product
every 6 months. Do service on the product more often if it
is necessary.
● Make sure that all screws are correctly tightened and that
the wires are installed correctly to the frame and not
damaged after adjustments are made.
5.1 To clean the product
● Clean the product regularly.
● Clean with a mild detergent. Do not use degreasing
products that can penetrate the bearings and chain and
interfere with the lubrication.
EN