Kayoba 002-714, Руководство по эксплуатации, Страница: 24 / 26

EN
24
32 Saddle 1
33 Flat washer 3
34 Nyloc nut M8 3
35 Screw 4.2 x 18 mm 4
FIG. 1
ASSEMBLY
Battery
1. Release the battery cover and insert two AAA batteries in the
battery compartment on the back of the computer unit,
see diagram below.
2. Check the polarity of the batteries and that the battery
springs are in good contact with the batteries.
3. Replace the battery cover and check that it is secure.
4. The battery life is approx. 1 year during normal use.
5. If the display cannot be read, or only partially, remove the
batteries and wait 15 seconds before replacing them.
6. The exercise bike memory is deleted when the batteries are
taken out.
Front and back foot
1. Place the front foot (2) in front of the frame (1) and align the
screw holes.
2. Fasten the front foot on the front bracket on the frame with
2 screws, 2 spring washers and 2 dome nuts.
3. Place the back foot (3) behind the frame and align the screw
holes.
4. Fasten the back foot on the back bracket on the frame with
2 screws, 2 spring washers and 2 dome nuts.
FIG. 2
NOTE:
The end piece for the back foot can be adjusted in height to
ensure that the exercise bike stands firmly on the floor.
Pedals
NOTE:
The crank arms, pedals, pedal axles and pedal straps are
marked with R for right and L for left.
1. Insert the left pedal axle in the threaded hole in the left
crank arm. Screw tight the pedal anticlockwise by hand.
WARNING!
Do NOT turn the left pedal clockwise, this will damage the
thread.
2. Insert the right pedal axle in the threaded hole in the right
crank arm. Screw tight the pedal clockwise by hand.
FIG. 3
TECHNICAL DATA
Computer
Distance 0.1-999.9 km
Time 0:00-99:59 min
Odometer 0.1-999.9 km
Calories 0.1-999.9 kcal
Pulse 40-240 spm
Control unit 4-bit microprocessor
Battery 2 x 1.5 V AAA
Operating temperature 0 to 40˚C
DESCRIPTION
No. Description Qty
1 Frame 1
2 Front foot 1
3 Back foot 1
4 End piece for back foot 2
5 Screw M8 x 70 4
6 Spring washer 8
7 Dome nut M8 4
8 Crank arm 2
9 L/R Pedal 2
10 End piece for front foot 2
11 Sensor cable 1
12 Load wire 1
13 Extension cable 1
14 Screw M8 x 16 6
15 Bushing 1
16 Screw 1
17 Handlebar post
18 Flat washer 1
19 Load control 1
20 Cable to hand pulse sensor 2
21 Foam rubber grip 2
22 End piece, handlebars 2
23 Screw 4
24 Spring washer 10
25 Handlebars 1
26 Computer 1
27 Washer Ø 8.2 x Ø 20.2 2
28 Saddle post 1
29 Knob 1
30 Cover, handlebar post 1
31 Cover, saddle post 1