ZHEJIANG KAYO MOTOR CO., LTD.
www.kayomoto.com
- 24 -
Adjustment for the rebound damping of the rear shock absorber
adjusting screws
The rebound damping of the rear shock
absorber is controlled by an adjusting screw, which
can be adjusted with a flat-blade screwdriver.
When it is turned counterclockwise, the rebound
damping decreases; when it is turned clockwise,
the rebound damping increases.
Measure the distance from the center of the rear wheel to the rear fender in
suspension
The measurement procedure is as follows:
1, the whole motorcycle set up, so that the rear
wheel is completely suspended
2. Select a fixed point on the side of the rear fender
and mark it as "point 1".
3. Measure the distance from "Point 1" to the
center of the rear axle and record it as "A1".
4. Remove the motorcycle from the rack
Measure distance from center of rear wheel to rear fender under no load
The measurement procedure is as follows:
1. The motorcycle is righted so that the center
surface of the tire is perpendicular to the ground
2. Measure the distance from the center of the rear
wheel axle of the motorcycle to "point 1" and
record it as "A2".
3. Use single stand to support the vehicle
4. Calculate the difference between "A1" and "A2"
and denote it as "D1".
The value of "D1" when K6 motorcycle leaves
