8
BALANCE MODE SELECT
This wheel balancer 'S Default model is clamp
weigh for rim it not be show on the Control
panel .please learned of the matte.
After input three value and ratate the wheel
you can Select the balance mode according to
the weight adding position and the balance
mode.
Press the key” F “to select the “ST
“balance mode derict,Press the key” ALU”
to select the ALU balance mode.
When you
switch on the machine, the machine will
automatic enter into the dynamic balance
mode and no need to select .
DYNAMIC
—clip the weight on both sides of rim
（
dynamic balance test once start
）
For balancing standard steel or alloy wheels
Static-
This function is used if stick-on
weights are to be mounted to the center plane
( hidden ) and not to either inner or outer edges
of the wheel.
ALU1
- to balance the light aluminum alloy rim .
This function is used if stick-on weights are to
be mounted to both inner and outer planes of
the wheel.
ALU2
- for ALU rim, hidden weight inside.
This function is used if stick-on weights are to be
mounted to the inner and center planes of the
wheel.
ALU3 -
clip the weight inside and the position
to add weight outside is same to ALU2.
Entering Wheel Measurements
Input A value
Pull the scale to the inner position to add the
weight and press the key A+ or A- to input the A
value into the display.
At this moment, the display will display “A”
：
“XX”
，
And the default system is inch.
Input Br (RIM Breadth) Value
Use the Br measurement caliper to measure the Br
of the rim, press the key B+ or B- to input the Br
value into the display. At this moment, the display
will display “B”
：
“XX”
Input the DiA(Diameter)Tire Diameter Value
After confirming the rim diameter, press the key D+
or D- to input the rim diameter into the display. At
this moment, the display will
display “D”
：
“XX”
