9
1.
When power starts, push the wheel by hands
to assist starting which will extend motor’s life.
2.
Make sure the wheel value is correct.
3.
Make sure the rim structure is suitable for
the balancing mode
4.
Make sure the quick nut is well tightened
5.
As the balance is over, unload the tyre, pay
attention to handling with care , don’t strike the
main shaft.
6.
Weights must be attached securely to wheel
surfaces cleaned according to weight
manufacturer’s recommendation. Failure to do
so may cause weight to come loose during a
spin, resulting in personal injury.
Balance the Wheel
1. Plug in the unit and turn on the Power Switch
2. Mount the Wheel following
3. Enter the rim data
4. Pull the Hood over the wheel and press Start on the
Control Board. The wheel will begin to spin.
5. When the cycle is finished, the wheel will stop
spinning and the Control Board will display the amount
of weight needed to attach to the wheel on the Inner
and Outer UNBALANCE VALUE displays .
6.
Hand rotate the wheel, watching the Inside
UNBALANCE POSITION display. Stop rotating the
wheel when all the display leds flash. Attach the weight
to the top center of the rim inner edge .
7.
Continue rotating the wheel, until all the outside
UNBALANCE POSITION display leds flash. Attach the
weight to the top center of the rim Outer edge
,8. Lower the Hood and press Start on the Control
Board. The wheel will begin to spin.
9. When the cycle is finished, the wheel will stop
spinning. If the UNBALANCE VALUE in the Inner and
Outer displays are both [00], then the wheel is
balanced. If there are other values, then repeat the
steps to re-balance the wheel until a [00] reading is
achieved.