11
Maintenance And Servicing
Self-calibration
Self calibration has been finished in the factory. If
you use for a period of time or change part inside or
the result of the balance is not correct,
you can self correct it again.( Choose one
medium-size tyre to install on main shaft , 13 or14
inches are perfect). Input correct data of this tyre A,
L , D.
Attention: Fail to input the correct size will lead to
the machine works wrong.
◎
Press F key, hold on and press C
key in half a second ,
“CAL”-“CAL” displayed, leds are
all flashing. Only after leds all go
out can you move your finger away.
◎
Press START key, after the tire
stops, “ADD”-“100” displayed,
please clip 100g weight onto the
outside of the rim on the position of
12 o’clock
◎
Press START key, after the tire
stops, “100” -“ADD” displayed,
please clip 100g weight onto the
inside of the rim on the position of
12 o’clock
◎
Press START key, after the tire
stops, “END-CAL” displayed, that
means the self correction is over.
Lamps are all on when 100g counterbalance is rightly under
main shaft.
◎
Do
n’t move away the weight from the tire. Press
START key, after the tire stops, if it shows “100”-“00”,
that means the self-calibration is successful.
7.
Rotate the wheel counterclockwise, slowly
by hand, until the Control Board display flashes
as shown above. Make a mark at the top of the
tire (12 0’clock position), and label “P-tire”.
8. Rotate the wheel counterclockwise, slowly
by hand again, until the Control Board display
flashes as shown above. Make a mark at the top
of the Rim (12 O’clock position), and label
“P-rim”.
9. Remove the wheel from the Balancer and use
the tire changer to re-mount the rim with the rim
and tire markings aligned.
10.
Place a 10 gram weight on the marking and
press [START] to activate the spin cycle.
11.
Check to see if the wheel is balanced. Repeat
as needed.
12.
When finished using the Wheel Balancer,
Turn the Power Switch OFF, and unplug the
machine.
