Kato Imer CARRY 105 ELECTRIC POWER, Руководство по эксплуатации

Страница: 39 / 48

4 MAINTENANCE
MINIDUMPER
CARRY 105EP
30
4.5.2 REPLACE HYDRAULIC OIL FILTER
The filter is localised under the oil tank.
1. Relieve the internal pressure from the hydraulic tank by loosening oil fill plug (1).
2. Clean the area to keep dirt out of the filter base (2).
3. Position a suitable container under the filter to collect any oil leaks that may occur during the
replacement of the filtering cartridge.
Note: always dispose of used oil and filters as established by local regulations.
4. Remove the screws (3), the cover (4) and pull out the filter cartridge (5).
Note: the filter cartridge must be replaced. A used cartridge cannot be used again.
5. Insert the new cartridge (5), manually press into position and then apply the cover (4) and place it into
position using the screws (3).
6. Start and run the motor to fill the filter.
7. Pressurise the hydraulic tank: After extending all cylinders with the oil fill cap (1) open, close the cap.
8.
Inspect for leaks on the filter cover (4).
4.6 600 HOURS MAINTENANCE AND CHECKS (or 1 YEAR)
4.6.1 REPLACING THE HYDRAULIC OIL
1. Position the machine on flat ground with the cylinders of the
accessory-holder and, if any, the loading shovel fully open.
2. Insert the safety catch against any accidental lowering and turn off
the motor.
3. Clean the area to keep dirt outside the tank.
4. Relieve the internal pressure from the hydraulic tank by loosening
the fill plug (1).
5. Remove the oil drain plug (2). Drain oil into a container.
NOTE: Always dispose of used oil as established by local regulation.
6. CIean the inside of the tank with the clean oil.
7. CIean and install the drain plug (2).
8. Fill the hydraulic tank with oil. See Recommended lubricant table.
9. Start and operate the motor at idling speed for 5 minuets.
10. Operate the control levers to allow the hydraulic oil to circulate
through all hydraulic circuits.
11. Restore the machine to the original conditions and turn off the
motor.
12. Check the amount of oil in the tank on the level indicator (3) and
add oil, if necessary, to maintain optimal levels.
13. Pressurise the hydraulic oil tank with the cylinders of the
accessory-holder and, if any, the loading shovel fully open.
Remove the fill plug (1) and then install fill plug again.
14. Place the accessory on the frame, lower the loading shovel on the ground and stop the motor.
2
1
3
•
H
OT OIL AND COMPONENTS CAN CAUSE PERSONAL INJURY
.
•
A
T OPERATING TEMPERATURE
.
THE HYDRAULIC TANK IS HOT AND CAN BE UNDER
PRESSURE
.
•
T
O RELIEVE THE PRESSURE FROM THE HYDRAULIC TANK
,
LOOSEN THE OIL FILL PLUG
(1)
ON THE HYDRAULIC TANK
.
•
R
ELIEVE THE TANK PRESSURE WITH MOTOR OFF BY REMOVING FILL PLUG SLOWLY
TO PREVENT BURNS FROM HOT OIL
.
CAUTION