Kato Imer CARRY 105 ELECTRIC POWER, Руководство по эксплуатации

Страница: 30 / 48

3 USER INSTRUCTIONS
MINIDUMPER
CARRY 105EP
21
5 Remove the screws (1) and nuts (2) located on the sides of the load body and apply the "lift and right
support plates of the shovel's boom" (C-D) positioned on the sided of the load body by blocking the
screws and nuts removed earlier (lock them tightly).
Warning! Position the convex screw heads inside the load body.
6
Insert the “right and left booms of the shovel” (E-F) in the designated pins on the plates. Insert the d. 25
plain washer (3) and block with the relevant expansion ring (4).
7 Insert the cylinders of the shovel-s boom attaching the cap to the designated pins on the plates. Insert the
d. 25 plain washer (3) and block with the relevant expansion ring (4).
Warning! Make sure that the fittings to connect the hydraulic pipes are positioned upwards.
8
Lock the cylinder heads to the shovel's booms with the designated pins. Fix the pins with the M10x25
screw (5) and the d 10 plain washer (6).
Warning! Insert the pins into the side fitted with a locking plate so that, once it is positioned, the head of the
pin remains locked into place.
9
Bring the shovel to the ground. Fix the shovel to the booms using the M10x40 screws with the designated
nuts and washers. Check the planarity of the blade and that the booms are properly coupled. Lock by
tightening the screws fully home.
10 Remove the caps on the distributor after cleaning surrounding surfaces from any dirt.
11 Position the flexible pipes according to the sequence indicated in the diagram. Extend the pipes up to the
shovel cylinders, making sure they to not overlap or get tangled. Lock the supplied collars into position.
Warning! Make sure the protective gasket is
position in the side where the cylinders are
coupled. Thoroughly inspect the correct
assembly sequence.
12 Once the correct execution of the
assemble has been verified, fully tighten
all the fittings, pipes and locking collars.
13 Start the motor, remove the "safety
retainer" and lower the load body, gently
activate the shovel's hydraulic circuit,
checking it is operating properly according
to the operation conducted (point 2.1.3). If
it is operating correctly, pressurise the
circuit bringing the cylinders to end of
travel.
14 Check there are no leaks in the couplings.
Clean all surfaces from any traces of oil.
15 Restore the (A) and (B) protective covers
of the hydraulic system to their original
position.
The machine is ready for use again.
1
2
C
D
F
E
4
3
4
3
5
6
BLUE
BLEU
GRAY
RED
GRAY
RED
WHITE
WHITE