Kathy Ireland BUILDER Series, Руководство пользователя

Страница: 6 / 72

6
U.L. Model No.: 52-ANT
DOWNROD
CLEVIS
PIN
HAIRPIN
CLIP
MOTOR
COUPLING
HAIRPIN
CLIP
CLEVIS
PIN
LOOSEN
SETSCREWS (2)
Figure 3
3. Ceiling Fan Assembly
(Continued)
3.4
Loosen the Two Set Screws in the Motor Coupler .
Place the Hanger Ball/4 .5” Downrod Assembly into
the Motor Coupler, aligning the Clevis Pin Holes in
the Downrod with the Holes in the Motor Coupler
(Figure 3) .
The Clevis Pin MUST go through the Holes in the Motor
Coupler and the Holes in the Downrod .
Be sure to push the straight leg of the Hairpin Clip
through the Hole near the end of the Clevis Pin until
the curved portion of the Hairpin Clip snaps around the
Clevis Pin .
The Hairpin Clip must be properly installed to prevent
the Clevis Pin from working loose .
Pull on the Hanger Ball to make sure the Clevis Pin is
properly installed .
RETIGHTEN
SETSCREW
MOTOR COUPLING
RETIGHTEN
SETSCREW
DOWNROD
3.5
While pulling up on the Hanger Ball, retighten the Two
Set Screws (previously loosened) in the Motor Coupler
to secure the Hanger Ball/4 .5” Downrod Assembly into
place (Figure 4) .
NOTE: The set screws must be properly installed as
described above, or fan wobble could result.
Figure 4
It is critical that the set screws are securely tightened.
Failure to verify that the set screws are properly
installed could result in the fan falling.
WARNING
!
It is critical that the clevis pin in the motor coupler
is properly installed. Failure to verify that the pin is
properly installed could result in the fan falling.
WARNING
!
MOTOR
COUPLER
MOTOR COUPLER
LOOSEN
SET SCREWS (2)
RETIGHTEN
SET SCREW
RETIGHTEN
SET SCREW