11
CONNECTION AND SET-UP
Remove the wood screws supplied from their
transport attachment on the underside of the
respective mounting piece (2 pieces).
Vertically insert each mounting piece into the fi fth
slot from the edge, as shown in Fig. 1.
Then push each mounting piece downwards and
outwards (see Fig. 2) until they lie fl at on the receiver
casing (see Fig. 3).
Now press the mounting pieces fi rmly against the receiver casing
at the points shown arrowed in Fig. 3), until the catch audibly snaps
home in the receiver casing.
Now hold the receiver, with the mounting kit attached, at the installation
location. Screw in the wood screws supplied, through the smaller
positions in the screw attachment area (4 x) (see Fig. 4). Wherever
possible, use the wood screws supplied. If these are unsuitable,
other screws of adequate size and strength can be used.
Under no
circumstances however use countersunk wood screws, since
these can damage the attachment area (see Fig. 5).
Then screw all four screws fully home, so that the mounting kit is no
longer able to work loose.
SUSPENDED INSTALLATION
INSTALLATION ON A FIXED FLAT SURFACE
So as to prevent the receiver slipping or falling, the mounting kit can also be attached to the underside
of the receiver. Assembly is the same as for suspended installation, except that the mounting kit is hooked
into the underside of the receiver.
or
