Kathrein MobiSet 4 CAP 920, Оригинальное руководство по эксплуатации

Страница: 16 / 56

16 from 56
Installation and connection
●
To prevent water vapour from inside the vehicle reaching the turntable through the roof gland, thread the
three cables through the sealing gasket supplied (see Fig. E2), close the gasket and insert it into the roof
gland until it reaches the stop. Make sure that no tensile load is acting downwards on the sealing gas-
ket as this can cause it to fall out in the course of time.
Version with external cable gland (Fig. F)
● Lay the cables supplied with the turntable (2 × coax cables and 1 x power supply cable) into the mount
-
ing plate as indicated by the markings on the mounting plate (see Fig. F), and feed the remaining lengths
of cable through a cable duct*
)
and a cable gland¹
)
into the interior of the motor home / caravan.
●
Lift up the turntable and place it carefully on the mounting plate facing in the direction of travel (see
Fig. F2) (do not step on the plug connectors and do not kink / crush the cables!)
The through holes on the turntable must be perfectly aligned with the threaded holes on the mounting
plate.
●
Allow the turntable to rest on the front edge of the mounting plate. Keep the turntable supported at an
angle (see Fig. F1) and insert a suitable piece of wood underneath it.
●
Now lay and connect the turntable cables on the mounting plate (as indicated on the mounting plate, see
also Fig. F1). Make sure that the cables are not crossed over and that they are taut so that they can-
not be crushed. The two master coaxial cables, marked red, must be connected to each other. Initially
tighten the coaxial cable plugs finger-tight, using no tools, then tighten them lightly using an open-ended
SW 11 spanner. Do not try to pull the cables from the unit. This could damage the cables or loosen the
cable connections.
● Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening
screws into the thread.
Tighten the screws to a torque of 6 Nm.
●
Run the connecting cables through the waterproof HDZ 100
1)
roof gland into the interior of the vehicle.
In so doing the cables may not be crushed, kinked or damaged.
Important
The connecting cables between the turntable and the connecting/control unit may not be extended.
1)
The HDZ 100 roof gland is available as an accessory under part number 20410032 from specialist
dealers.