8
4.
Break open the recesses intended for wall mounting.
5.
Use the provided screws to screw the water sensor tightly to the wall.
6.
Close the housing again.
7.
To prevent that the cable to hanging loosely from the wall, use the plastic
clips to attach it. Remove the double-sided adhesive tape and place the cable
of the water sensor into the clip.
Floor mounting:
•
If the three sensors at the bottom of the water sensor’s housing detect
water, it triggers an alarm as well.
•
For this purpose, place the water sensor with the golden sensors facing
downwards on the floor.
•
Since the water sensor is not entirely watertight, you should react
promptly in case of an alarm. Otherwise, the device will possibly be
destroyed/damaged by the rising water.
Notes:
•
In case of longer contact with water, the water sensor sends an alarm
signal to the alarm panel every ten minutes. If the water level drops again,
the water sensor returns to normal operation.
•
You can extend the external water probe e.g. by means of a luster terminal
and another cable.
•
The water sensor is not compatible with the wireless repeater and cannot
be saved in the backup file.
www.kathrein-ds.com
9360000386/b/STM/0321/GB | Subject to change.
KATHREIN Digital Systems GmbH | Anton-Kathrein-Str. 1–3 | 83022 Rosenheim | Germany | Phone +49 731 270 909 70
