Katalyst asurion uBreakiFix Fixture, Руководство пользователя

Страница: 18 / 33

Plain or DF Tape Mount
Install Instructions
Smaller flat cut Letters / Logos
Flat, Smooth Interior Surface
Small, typically under 6" flat cut letters, interior install.
Tools Required: Stencil Guide, level, masking tape,
tape measure, cleaning cloth, adhesive and/or VHB tape.
1. CLEAN Mounting Surface
Clean and prepare mounting surface before starting your install.
Tip: Mounting surface MUST be flat, smooth, free of dust and moisture.
2. POSITION and Secure Guide
Position guide flat on wall. Center & level copy, then secure with masking tape.
Confirm proper spelling, spacing and kerning of letters on guide.
Note: Larger & heavier flat acrylic may require VHB tape
and adhesive, to safely install. Use an adhesive, such as
Epoxy, that will bond with the letters & mounting surface.
3. INSTALL Letters Using Guide
Remove masking from VHB tape and install letters on wall, using your guide.
Do NOT press hard on letters yet - lightly set letters on wall.
View letters from a distance to make sure they are visually straight - adjust
and align as needed.
4. PRESS Letters to Set
After letters are aligned straight, apply additional pressure to the face of each
separate letter. VHB tape requires
pressure to properly set.
Press letters hard with fingers, roller or flat board to fully set the VHB tape.
Remove Stencil Guide after letters are set.
Tip: 3M recommends 25psi min. pressure to set tape (firm hand pressure)
5. REMOVE any Face Masking
Once letters are secured, carefully peel off any protective letter face masking.
Clean off letter faces as needed.
GI-DF/FA/SI-33017