5
Warranty Policy
Warranty Period:
Models 2400D, 3400D/HD, 4400D/HD- 2 years
Kasco® Marine, Inc. warrants this De-Icer to be free
from defects in material or workmanship (except for
the ropes, power cord, and propeller) under normal use
and service. The Kasco Marine, Inc. obligation under
this warranty is limited to replacing or repairing free
of charge any defective part within the warranty pe-
riod. Customer shall pay shipping charges for return-
ing the unit to Kasco or an Authorized Repair Center.
THIS WARRANTY IS IN LIEU OF ANY OTHER
WARRANTIES, EXPRESSED OR IMPLIED, AND
ANY OTHER OBLIGATION OR LIABILITY
WHATEVER ON THE PART OF KASCO MARINE,
INC. AND IN NO EVENT SHALL KASCO MA-
RINE, INC. BE LIABLE FOR ANY SPECIAL OR
CONSEQUENTIAL DAMAGES.
Warranty is void if:
The De-Icer is not maintained properly according
•
to the Maintenance Recommendations supplied in
this Owners Manual.
The De-Icer is returned for repair without the
•
power cord or if the unit, control box, or power
cord are altered in any way from original ship-
ment. Cuts in the power cord are not covered
under warranty.
The De-Icer is damaged by unauthorized tamper-
•
ing.
The Sacrifi cial Zinc Anode around the propeller
•
shaft shows signifi cant deterioration. (The Anode
must be inspected periodically and replaced if
necessary.)
Angling your Kasco De-Icer with suspension
operation can be accomplished easily by simply
changing the mounting location of one suspension
line. There is no need to remove the knot and splice
of the rope, simply change the point at which the line
leaves the propeller cage by looping the rope around
the top circular band over 1 to 4 vertical cage wires
(more than 4 not recommended. This will move the
support lines off center and allow the unit to hang at
a slight angle. After installation and the unit is turned
on, your Kasco De-Icer will swing up to an angle (the
angle is dependent on how many cage wires you move
the line) and the De-Icer will hold that angle during
operation. This allows you to aim the fl ow of warmer
water in the desired location. If the Universal Dock
Mount or Horizontal Float were purchased, see their
Assembly and Installation Instructions.
STEP FIVE
Once your De-Icer is properly installed and secured,
you can now plug the unit into a properly grounded
and GFI protected circuit. If a C-10 Thermostat or
C-20 Timer/Thermostat Controller was purchased,
they can be plugged into the outlet receptacle and the
De-Icer plugged into the controller.
STEP SIX (OPTIONAL)
On installations where open water area is required or
desired to be limited/controlled, a curtain technique
can be used to block the fl ow of water and restrict the
open water area. By draping a canvas tarp as a curtain
in the water, you can successfully disrupt the fl ow of
water from the De-Icer. The canvas can be tied above
the water level and weighted at the bottom (easiest if
you fold the tarp in half and lay a chain in the fold as
the weight). The curtain needs to hang into the water
a few feet. This curtain will allow you to protect only
the area you need. As always, we recommend the ice-
free area is well marked.
