4
Quick Disconnect Installation
Important – Read Carefully Before Installation
Before using the connector, it is important that these instructions are carefully read and understood to ensure the connector system is
completely water tight and electrically safe.
IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN.
The socket (female) insert of the connector must be the live part of the connector from the supply. The pin (male) insert of the con-
nector must lead to the load or electrical device. On 50Hz units, the pin (male) insert of the connector is installed at the factory. To
ensure efficient sealing, use only smooth circular cable.
Note:
White gland for 9-11mm O.D.
Yellow gland for 13-15mm O.D.
Assembly/Wiring Instructions
STEP ONE
Remove the socket insert from the housing of the connector. There is a slot for a flat blade screwdriver in the center of the insert.
Note: The inserts have a LEFT HAND THREAD and should be turned clockwise to remove.
STEP TWO
Remove the gland nut and gland from the rear of the
housing and slide on to the cable. Make sure the gland is
orientated with the stepped edge facing the gland nut (see
picture).
STEP THREE
Prepare the cable and strip wire ends as shown.
STEP FOUR
Insert the stripped wire ends into the terminals on the back of the Pin/Socket insert and fully tighten the wire retention screws. (Refer
to figure for correct wire orientation).
After the wires have been connected securely, pull the cable and insert back into the housing and tighten with a screwdriver to ensure
the insert is seated correctly. Note: LEFT HAND THREAD, turn the insert counter clockwise to tighten.
Pin Insert (Installed on Stub Cord)
Pin Insert
Main Body
Gland
Gland Nut
Wire Stripping
Wire Stripping
Socket Insert (User Installed)
Socket insert
Main Body
Gland
Gland Nut
Stepped Edge
