Kärcher MIC 50, Руководство пользователя, Страница: 67 / 342

English 67
1. The attachments are fitted on a Kärcher interchangeable
frame or on an integrated interchangeable frame from the at-
tachment manufacturer, and are fitted and secured on the at-
tachment frame.
1
Control lever
2. The attachment frame is controlled using the control lever at
the right of the joystick.
1
Switch for "double-acting control hydraulics AUX rear" / "at-
tachment frame with tipping function"
3. To activate, switch the switch over to "attachment frame with
tipping function".
9.4.2 Mounting options on the attachment frame
1
Mounted spreader
2
Interchangeable frame (integrated in the attachment)
3
Attachment frame with tipping function
1. Attaching / removing is described using the example of a
mounted spreader.
9.4.3 Setting the fixing
Note
The setting for the fixing of the interchangeable frame must only
be made during first installation or when fitting to another carrier
vehicle.
1
Screw with nut
2
Fixing hook (2x)
3
Attachment frame
1. Undo the nuts to the left and right by about 1 revolution.
2. Fit the attachment to the attachment frame and secure it using
retaining pins and retaining clips, see the following chap-
ter9.4.4 Fitting the attachment to the vehicle.
3. Completely lower the attachment frame.
4. Press the fixing hook against the attachment frame as shown.
5. Re-tighten the nuts to the left and right.
9.4.4 Fitting the attachment to the vehicle
1
Vehicle rear
2
Retaining pin with retaining clip (2x)
3
Attachment
4
Rear supports
5
Fixing hook (2x)
6
Front supports
1. Remove the retaining pins from the attachment frame to the
left and right (retaining pin and retaining clip are a part of the
attachment frame).
2. With the vehicle rear centred and parallel, (carefully) drive un-
der the attachment standing on supports as far as you can go.