Kärcher MC 250, Руководство пользователя

Страница: 25 / 132

English 25
2
Lower waste container switch setting
6. Operate the switch.
7. Empty the waste container.
Note
Always raise the waste container fully to the end posi-
tion.
If necessary, remove any adhering soiling with a dirt
scraper (optional) and clean with water. See chapter
"Cleaning the waste container"
1.1.4 EU Declaration of Conformity
We hereby declare that the machine described below com-
plies with the relevant basic safety and health require-
ments in the EU Directives, both in its basic design and
construction as well as in the version placed in circulation
by us. This declaration is invalidated by any changes made
to the machine that are not approved by us.
Product: Sweeper
Type: PF-E (MC 250)
Currently applicable EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2000/14/EC
Harmonised standards used
EN 13019
CISPR 12
Applied conformity evaluation method
2000/14/EG: Appendix V
Sound power level dB(A)
MC 250 Euro 6
Measured: 106
Guaranteed: 108
MC 250 Stufe V
Measured: 105
Guaranteed: 108
The signatories act on behalf of and with the authority of
the company management.
Documentation supervisor: S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2020/01/01
1.2 Opening/closing the lock
The locks secure the attachment devices (e.g. sweeping
system). These are located on the left and right sides in the
area in front of the front wheel and are recognizable as yel-
low levers.
몇
CAUTION
Danger of accident
Check the locking mechanism for correct adjustment with
each attachment.
1
Screw (18 mm)
2
Yellow locking level
3
Handle
4
Mounting arm from attachment
Opening the lock
1. Loosen the screws from the left and right locking levers
by approx. 1 cm.
The lock is released.
2. Lift the locking lever on the side handle, then push it
back. The attachment can be attached.
Locking the lock
3. Insert the mounting arm from the attachment all the way
to the end stop.
4. Push the locking lever forwards.
5. Tighten the screw, check that the attachment is securely
attached.
1.3 2-brush sweeping system attachment (ex
works)
1.3.1 Requirements for removal/installation
A changing carriage is required for removing/attaching the
sweeping system.
Note
Optional accessory, order no. 2.852-862.0
1 Park the vehicle on a level surface.
2 The brush system must be sitting on the changing car-
riage for removal/installation from/on the vehicle. Use a
lift truck for removal/installation.
3 The corresponding > Sweep < program must be select-
ed on the display.
1.3.2 View of the device for a 2-brush sweeping
system
Figure: Sweeping system attached
1
2-brush sweeping system with suction mouth
Chairman of the Board of Management
Director Regulatory Affairs & Certification
H. Jenner S. Reiser