English
KSM 750 BAT/PROFI/USA
16
UTILISATION FOR THE INTENDED
PURPOSE ONLY
♦
This sweeper is intended for
sweeping inside- and outside
surfaces.
♦
It corresponds to the L utilisation
classification for non-health
hazardous dusts.
♦
It is not intended for use on public
traffic routes
FUNCTIONAL DESCRIPTION OF
SWEEPER
The KSM 750 operates according to
the throw-over principle!.
•
The side brush (1) cleans corners
and edges of the sweeping surface
and transports the dirt in the path of
the main brush.
•
The rotating main brush (2)
transports the dirt directly into the
debris container (3).
•
The dust swirled up in the container
is separated by way of the dust
filter (4) and the filtered, clean air
removed by the suction turbine (5).
DEVICE ELEMENTS
1. Push handle
2. Lever for lowering and raising the
side brush
3. Lever for lowering and raising the
coarse-dirt flap
4. Charging control indicating
instrument for batteries
5. Unit cover
6. Debris container with transport
rollers and push handle
7. Filter shaker for the dust filter
8. Battery charger plug connection
9. Lever for forward travel
1. Main switch
2. Latch for debris container
3. Drive wheels
4. Coarse-dirt flap
5. Swivel caster with parking brake
6. Side brush
7. Cover latch
BEFORE OPERATION FOR THE
FIRST TIME
Unloading instructions
Proceed as follows when
unloading:
Cut the plastic packing tape and
remove the film
Knock aside the wheel securing
blocks and lift the machine off the
pallet by hand
Installation
Fitting thrust clip
Install the batteries
Charge the batteries
See maintenance tasks chapter for
description
EACH TIME BEFORE OPERATION
General instructions
Park the sweep suction machine on
a level surface
Shut-off the engine
Set parking brakes on the front of
the swivel caster
Inspection and maintenance work
♦
Check the battery charge state
Master switch setting "1"
Battery indicating instrument (KSM
750 BAT)
If the pointer is no longer in the
green area, the batteries must be
charged.
Battery indicating instrument with
deep-discharge protection (KSM 750
Profi/USA)
•
If red diode (1) lights, battery is flat
•
If yellow diode (2) lights, battery
charge is still 20%
•
If green diode (3) lights, battery
charge is more than 20%
Note:
The units turns off automatically in
case of deep discharging.
Recharge the battery when the
yellow or red diode is lit.
Check the side brush
Check the sweep roller
Clean filter
Empty the swept material container
See maintenance tasks chapter for
description
COMMISSIONING
Note:
Initial operation permissible only if the
unit‘s cover is closed!
Start-up the machine
Release parking brake
Switch-on the engine
•
Master switch setting "1"
Note:
The sweep roller and side broom
rotate
Содержание KSM 750 BAT
Страница 14: ...KSM 750 BAT PROFI USA 158...