Kärcher KM 100 R D, Руководство пользователя

Страница: 23 / 364

-
8

Pull out roller brush swinging arm.
 Remove the roller brush cover.
 Pull out roller brush.
Installation position of roller brush in direc-
tion of travel
 Push new roller brush into the roller
brush housing and onto the drive pin.
Note: When installing the new roller brush,
ensure correct positioning of the bristle as-
sembly.
Note: Adjust the bowden cable, so that the roll-
er brush is lifted approx. 10 mm off the floor.
 Position roller brush cover.
 Install the roller brush arm.
 Hook the Bowden cable in.
 Tighten the fastening screws.
 Screw on side panel.
 Push in the waste containers on both
the sides and lock them.
 Set programme switch to step 1 (driv-
ing). The side brush and roller brush are
raised.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Set programme switch to step 2. Roller
brush is lowered. Slightly press down
on the drive pedal and allow the sweep
brush to briefly rotate.
 Raise roller brush.
 Press pedal which raises bulk waste
flap and keep pressed.
 Drive machine backwards.
The sweeping track should have an even
rectangular shape which is between 50 and
70 mm wide.
Note: The side brush floating mounting of
the roller brush adjusts the sweeping track
as the bristles wear down. The roller brush
must be replaced if it becomes too worn.
 Park the sweeper on an even surface.
 Set programme switch to step 1 (driv-
ing). Roller brush is raised.
 Turn main key to "0" and remove it.
 Secure the machine with wheel
chock(s) to prevent it from rolling away.
 Raise slightly the waste containers on
both sides and pull them out.
 Open the fastening screws of the side
panels on both sides.
 Remove side panels.
 Front sealing strip

Slightly loosen retaining nuts for the
front sealing strip; to replace, unscrew.

Screw on new sealing strip without fully
tightening the nuts.
 Adjust sealing strip.
 Set the distance of the sealing strip to
the floor so that the bottom edge trails
behind at a distance of between 35 and
40 mm.
 Tighten nuts.
 Rear sealing strip
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 5 and 10 mm.
 If worn, replace.
 Remove roller brush.
 Unscrew retaining nuts for rear sealing
strip.
 Screw on new sealing strip.
 Side sealing strips
 Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
 Screw on new sealing strip without fully
tightening the nuts.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
 Adjust sealing strip.
 Tighten nuts.
 Screw on side panels.
 Push in the waste containers on both
the sides and lock them.
Check the sweeping mirror of the
sweeping roller
Adjusting and replacing sealing strips
23 EN