Kärcher IP 120, Руководство пользователя

Страница: 14 / 157

14
English
Î Press "On" key.
Î The pellet production will start.
Once the desired quantity of pellets has
been produced, the machine will switch
off.
Î Press "Off" key.
Î Remove the full container from the
scale.
In automatic mode, pellets are produced for
a preset length of time. After that, the ma-
chine will terminate the pellet production.
Î Place an empty container below the pel-
let ejector.
Î Rotate the key switch "Direct/PCS" to
"PCS".
Î Press "On" key.
Î Use the rotary knob to set the produc-
tion time/volume.
Î Press the key "Start PCS".
The pellet production will start.
Once the preset time has elapsed, the pro-
duction of the pellets will be terminated.
Î Press the key "Start PCS" once again in
order to repeat this production time pe-
riod.
Î Press "Off" key to end production.
Î Press emergency-stop button.
Î Shut off the carbon dioxide supply.
Î Press the "On" key and let the machine
run until the manometer displays "Car-
bon dioxide 0".
Î Press "Off" key.
The machine will finish the current pro-
duction cycle and will then terminate the
pellet production.
Î Turn the main switch to position "0"
The extruder plate can be replaced to
change the pellet diameter.

Danger!
Risk of accident while working on the appli-
ance. Carry out all the steps described in
the chapter "Shut down" before starting
anhy work on the device.

Danger
Risk of cold burns on account of dry ice or
cold parts of the machine. While working on
the machine, wear appropriate safety gear
for protection against cold or remove dry ice
and let the machine heat up.
Avoid bodily contact with dry ice.
Never put dry ice in your mouth.
1 Pellet ejector
2 Extruder plate nut
3 Pellet ejector nut
4 Extruder plate
Î Unscrew the pellet ejector nut.
Î Remove the pellet ejector.
Î Unscrew the extruder plate nuts.
Î Remove the extruder plate.
Î Insert the other extruder plate in reverse
sequence.
Producing pellets
Automatic operation with the instal-
lation set "Volume control PCS"
(option)
Switch-off in case of emergency
Shutting down Replace the extruder plate.