Kärcher ID 30/30 Afc, Перевод оригинального руководства по эксплуатации

Страница: 23 / 49

Troubleshooting and fault elimination
23/49
Troubleshooting and fault elimination
Safety instructions
WARNING
Before starting work remove the plug from the wall socket!

Before work for troubleshooting is started, the parking brakes at the undercarriage must be activated.

If harmful substances escape due to a defect (eg filter defect), the machinery must be switched off
immediately and the room has to be aired or leave!
• Before starting any work on the industrial vacuum cleaner, but particularly before opening covers of
live or moving parts, the industrial vacuum cleaner or system must be correctly disconnected from
the mains and the drive unit must have stopped
• The measures specified below may only be withdrawn when the industrial vacuum cleaner is
completely reassembled and the maintenance is concluded.
•
The usual safety regulations are, for example, in accordance with VDE 0105 :
– Disconnect from mains
– Provide a safeguard to prevent unintentional restarting
– Check that the equipment is not live
– Cover or shield adjacent live parts.
Initial fault elimination measures
könne
All the errors mentioned in the table below may be eliminated by yourself. In case of major problems
or other failures please contact the customer service of Ringler immediately.
Tel. ++49-(0)7171-94888-0
Perform maintenance tasks in accordance with the description in the Maintenance/Servicing chapter
Interference Possible cause Remedy
Reduced
suction
power

Extraction hose or nozzle clogged

Extraction hose leaking

Extraction hose not fitted correctly in extraction
socket

Collection container full

Area filter/pocket filter contaminated

Seal between drive unit and collection container
defective

Extraction turbine defective

Remove clogging

Replace hose

Insert hose correctly

Empty collective container

Clean or replace filter

Clean or replace seal

Replace suction turbine by
electrician
Device not
running

Rotary field monitoring reports motor was turning
in the wrong direction

Inspection by electrician/phase
run
Extraction
motor is not
running
correctly

2 phase run

Motor protection switch has triggered

Fuse triggered

Inspection by electrician
Fuses trigger

Fuse too low

Defective switch

Defective motor

Inspection by electrician
Motor runs
too hot

Cooling air volume too low, cooling air paths
clogged

Ensure uninhibited supply and
exit of cooling air