Kärcher HDS 655 M Eco, Инструкция по эксплуатации

Страница: 25 / 36

English
25
! Connect ray tube with hand spray gun
! Insert high pressure nozzle into cover-
ing nut
!
Install covering nut and tighten firmly
Figure 4
! Install the hose drum with the enclosed
screws, discs and nuts (4 pieces each).
Figure 5
! Connect the high pressure hose to the
high pressure connection point of the
hose drum and the appliance.
! Connect the high pressure hose of the
hand-spray gun to the hose drum.
!
Wind the high pressure hose with the
least possible bends (in the clock-wise
direction) on the hose drum.
n
Warning
Roll off the high-pressure hose from the
hose-drum completely while operating the
machine.
Figure 6
Figure 7
For connection values refer to technical
specifications
Figure 1 - Pos. 18
! Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note
The supply hose is not included.
If you want to suck in water from an exter-
nal vessel, the following modification is
necessary:
!
Remove water connection from the
pump head.
! Unscrew the upper supply hose with the
fine filter to the swimmer container and
connect it to the pump head.
!
Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the
water connection point.
– Max. suck height: 0.5 m
Until the pump sucked in water, you should:
! Turn the pressure and quantity regula-
tion to MAX.
! Close the dosing valve for the deter-
gent.
m
Danger
Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.
– For connection values, see technical
data and type plate.
– The electrical connections must be
done by an electrician according to IEC
60364-1.
n
Warning
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded.
n
Warning
Check direction of rotation of the engine at
every socket change.
– With correct direction of rotation a
strong airflow can be felt out of the ex-
haust opening of the burner.
Figure 16
! Exchange the poles at the device plug if
the rotation direction is wrong .
!
If you have to use an extension chord,
then the same must always be rolled up
and have an adequate cross-section.
Install the hand-spray gun and hose
drum (appliances with hose drum)
Installing spare high pressure hose
Installing the handle
Water connection
suck in water from vessel
Power connection