Kärcher HD 1050 DE Cage, Оригинальное руководство пользователя

Страница: 15 / 280

– 4
 Connect high pressure hose and spray
pipe to the hand spray gun.
 Tighten the screw connection of the
spray lance finger tight.
 Install the nozzle on the spray pipe in
such a way that the marking is on the top.
 Tighten covering nut firmly.
 Connect the high pressure hose to the
high pressure connection point of the
machine.
For connection values refer to technical
specifications
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4“) to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
 Open the water supply.
Note: The supply hose is not included.

DANGER
Never suck water from a drinking water
container.
Never suck in liquids which contain sol-
vents like lacquer thinner, petrol or oil. The
spray mist of solvents is highly inflamma-
ble, explosive and poisonous.

Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the
water connection point.
 Set dosing value for detergent to "0".
 Remove air from appliance before oper-
ation.
 Open the water supply.
 Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
 To dearate the appliance, unscrew the
nozzle and allow the appliance to run until
the water exits in a bubble-free state.
 Switch off the appliance and fit the noz-
zle again.
 DANGER
Risk of explosion!
Do not spray flammable liquids.

DANGER
Risk of injury! Never use the appliance
without the spray lance attached. Check
and ensure proper fitting of the spray lance
prior to each use. The screw connection of
the spray lance must be finger-tight.

DANGER
– Place the appliance on firm surface.
– The high-pressure cleaner must not be
used by children. (Risk of accidents on
account of improper use of the device).
– The high-pressure jet generates high
levels of noise when the device is in
use. Risk of hearing impairment. Al-
ways use proper hearing protection
while working with the device.
– The water jet coming out of the high-
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can
cause additional torque. Hence, hold
the spray lance and gun firmly.
– Never direct the water jet on to persons,
animals, the appliance itself or electrical
components.
– Vehile tyres/ tyre valves may be
cleaned only with a minimum spray dis-
tance of 30 cm. Otherwise, the high
pressure spray can cause damage to
the vehicle tyre/ tyre valve. The discol-
ouring of the tyre is the fhe first sign of
damage. Damaged vehicle tyres are a
source of danger.
– Do not spray materials containing as-
bestos or other health-hazardous sub-
stances.
Install hand spray gun, spray lance
and nozzle
Water connection
Suck in water from vessel
1.
2.
Dearating the appliance
Operation
15 EN