14
English
5.906-522.0 Rev. 01 (08/11)
1 Rubber bearing on the engine
Check correct position of the engine bearing.
Thread in the engine pinion on the toothed wheel
and place the engine into the engine mount.
1 Locking wedge
2 Clamp pocket on engine
Insert the locking wedge into the clamp pocket on
the engine but do not press in yet.
Position the engine mount and tighten the screws.
This will make the locking wedge slide deeper into
the clamp pocket.
Press the locking wedge down another two notch-
es.
Install the electronics cover as described in the
chapter "Replacing the brush roller".
Remove the electronics cover as described in the
chapter "Replacing the brush roller".
1 Motor
2 Engine mount
3 Fastening screws, engine mount
Unscrew the fastening screws of the engine mount
and remove it.
5.2.6 Replace the motor.
