Page 15
Page 14
Replacement of LED illuminant– A: Access to LED illuminant
In order to be used for a long time, the hanging lamp BUOY.3000 is constructed
so that the LED illuminant may easily be replaced at the end of its lifetime.
Important: Replace the original Osram LED illuminant exclusively by a non-dim-
mable LED illuminant with a maximum of 5W. The use of other illuminants with
GU10 base is explicitly not allowed and may lead to a security risk. Non-obser-
vance leads to loss of warranty and liability of the manufacturer.
Disconnect the hanging lamp from the electric circuit before opening it by switching
off the upstream fuse/the residual current circuit breaker.
Opening of the lid/the illuminant holder:
I. Hold the lamp shade
2
tightly, put one arm around it or arrange for another
person to hold the lamp shade
2
.
II. Unscrew the lid
3
of the lamp shade
2
.
III. Carefully pull the lid
3
with the illuminant
11
and the centring ring
10
out
of the lamp shade
2
until you see the lamp carrier
9
– the illuminant unit is
protected from being pulled out further via the cable screwing
1
.
Now the LED illuminant can be changed. The procedure of removal and installation
is described on the following pages.
IV. In order to close the lid, proceed in reversed order.
