Kantronics KAM, Инструкция по эксплуатации

Страница: 39 / 55

SAMPLE TERMINAL PROGRAMS
35
BASIC terminal program for the Apple computer with the Super Serial Card
10 REM THIS PROGRAM SETS UP THE SSC FOR THE TNC
20 REM ASSUMES THE SSC IS IN SLOT #2
30 A$=CHR$(1):D$=CHR$(4)
40 PRINT D$;"PR#2"
50 PRINT A$;"6 BAUD": REM SET 300 BAUD
60 PRINT A$;"0 PARITY":REM NO PARITY
70 PRINT A$;"SD":REM DISABLE SPECIAL CHARS & ENABLE ESC KEY
80 PRINT A$;TERM MODE"
90 REM IN TERMINAL MODE-TALK TO TNC
100 REM PRESS<CTRL RESET>TO EXIT PROGRAM
110 PRINT A$;"RESET"
120 END
BASIC terminal program for the Zenith Z-100
10 KEY OFF: CLS: CLOSE
20 OPEN"COM1:300,8,N,1" AS #1
30 OPEN"SCRN:"FOR OUTPUT AS #2
40 A$=INKEY$:IF A$=""THEN 60
50 PRINT #1,A$
60 IF LOC(1)=0 THEN 40
70 B$=INPUT$(lOC(1),#1)
80 PRINT #2,B$
90 GOTO 40
BASIC terminal program for the Atari 850 Interface
10 GOSUB 1600
20 FOR LOOP=0 TO 1 STEP 0
50 IF PEEK(764)=255 THEN 80
60 GET #KEY,A:IF A=125 THEN A=8
70 PUT #1,A
80 STATUS #1,A:BUF=PEEK(747)
90 IF BUF=0 THEN NEXT LOOP
100 FOR I01 TO BUF
110 GET #1,A:IF A=8 THEN A=126
120 ?CHR$(A);:NEXT I
140 NEXT LOOP
1600 KEY=4
1610 XIO 36,#1,8,0,"R1:":REM-300 BAUD
1630 XIO 34,#1,48,0,"R1:"
1640 OPEN #1,13,0,"R1:"
1650 XIO 40,#1,0,0,"R1:"
1655 OPEN #KEY,4,0,"K:"
1660 RETURN
This program uses a 5-wire cable as described in the Connecting Your Computer section. When us-
ing this program, set the TNC's DELETE and AUTOLF commands to OFF.