Kantronics KAM, Инструкция по эксплуатации

Страница: 28 / 55

ASSEMBLY / DISASSEMBLY
24
Assembly and Disassembly of the TNC
Should you require access to the TNC to reposition jumpers or for other purposes, disassemble as
follows:
1. Turn off power to your TNC and remove all cables from he unit.
2. Using a small phillips screwdriver, remove the two front panel screws just far enough to free
the panel and bezel.
3. Carefully remove the front panel and bezel.
4. Note the screw holding the voltage regulator to the metal case. Remove this screw. (Does not
apply to KPC-4 .)
5. Slide the PC board out of the case.
To reassemble, reverse the procedure above. Be sure to re-install the screw holding the voltage
regulator to the case (not in KPC-4 ). Failure to do so will damage the unit as the case provides a
heat sink for the voltage regulator during normal operation. Do not attach cables to the rear of the
TNC without supporting the front of the PC board or having the front panel secured in place. Doing
so may break the voltage regulator secured to the front of the case.