Kantech Telephone Entry System, Руководство по установке

Страница: 14 / 42

DN1769-1809
8
Features
Compatible with any Access Controller Supporting a Wiegand Interface Port
• Any access controller with Wiegand reader port(s)
• Kantech KT-100, KT-300 and KT-400 controllers
Note: When the KTES is connected to a controller using the Wiegand interface, the control of the attached lock is
managed by the controller. This means the door locking device will be connected to the access controller and
not the KTES.
Compatible with all EntraPass Special, Corporate and Global Editions
The Kantech Telephone Entry System is compatible with all EntraPass Editions v4.02 and higher:
•
EntraPass Special Edition
• EntraPass Corporate Edition with a Corporate Gateway
• EntraPass Global Edition with a Corporate Gateway
Multiple Configuration Options
• Visual User Interface (VUI): The KTES can be configured locally with the VUI, refer to the Programming
Manual , DN1770 for details concerning the VUI.
• EntraPass: The KTES can be configured and monitored through the EntraPass system, refer to the
corresponding EntraPass Reference Manual , for additional details.
Communication Ports
• 1 10/100Base-T Ethernet for network connection with the EntraPass Gateway
•
1 (TIP and RING) terminal block for phone line connections and for multiple KTES sharing the same
telephone line
•
1 RS-485 (COM1) for RS-485 communication with the EntraPass Gateway
Inputs
There are four (4) onboard inputs on the KTES. They are configurable with EOL (End-of-Line) resistor, without
EOL resistor, or with double EOL resistors. Respective alarm response timers are also programmable. By default,
Input 1 is assigned to the door contact and Input 2 is assigned to the postal lock. Each input can be individually
configured for one of the following applications:
• Door Contact
• Postal Lock
• Rex (Request to Exit) Device
• General Supervised Input
DC Powered Lock Output
There is one (1) onboard DC powered lock output and it is supervised.
Relay Outputs
There are three (3) onboard relay controlled outputs. The locking function can also be performed by any onboard
relay configured for lock output functionality.
Reader Interfaces
There are two (2) onboard reader interfaces. They can be programmed for one (1) Wiegand input port and one (1)
Wiegand output port.
Automatic Port Detection
The KTES can automatically detect the site communication RS-485 speed set by EntraPass as well as the
communication port which can be IP (ETHERNET #1), RS-485 (COM1) or Dialup modem.
Upgradable Firmware
The firmware program can be downloaded from any EntraPass workstation to the KTES. The firmware program,
stored in the KTES flash memory, is upgraded without having to change any parts.