Note 1: The MIN, MAX and AVE readings are the minimum, maximum and average readings
over the period from the start of the cycle.
Note 2: The RD value is the current reading.
Note 3: The speed of the display scrolling is dictated by the slowest sensor. The display will
scroll every time a new set of readings have been taken.
3.4.3. Calibration
To enter, scroll down in the set up menu and select either “ZERO CAL” on the Model 2710 or
“CALIBRATE” on the Model 2750.
To enter the calibrate menu the “mute” and “scroll down”
button needs to be held down for 2 seconds.
From here either “ZERO CAL” or “SPAN CAL” can
be selected.
For more information on how to calibrate the sensor heads please refer to
Section 6
of the User
Guide.
3.4.4. Mute Key
•
To mute the audible feedback “beeps” that occur when you press a button, scroll down in the
set up menu and select “MUTE KEY”. (Found under “MONITOR SETUP” in the Model 2750)
•
Press the enter key to silence the audible feedback “beeps”, the word muted will appear next
to MUTE KEY
•
On the Model 2710, if the device is turned off the mute settings will be returned to the default
state and will have to be reset when the monitor is restarted
3.4.5. Location ID (Model 2750)
•
To select the location ID, scroll down in the set up menu and select “LOCATION ID”
•
The location ID provides a means of identifying the location where a measurement was taken.
This can be used to quickly trace a measurement back to a location
•
Location ID is logged for each measurement
•
Press “enter” to confirm the ID and return to the set up menu
3.4.6. Monitor ID (Model 2750)
•
The monitor ID can be found under “MONITOR SETUP”, scroll down in the monitor set up
menu and select “MONITOR ID”
•
Each monitor can be numbered to identify them quickly when more than one is in use
Page | 11
Kanomax Gasmaster User Guide
MRK-D-0002 V3
