Model 2710
Model 2750
3.4.1. Units
•
To enter, scroll down in the set up menu and select “UNITS”. (Found under “MONITOR
SETUP” in the Model 2750)
•
Choose between ppm or mg/m
3
via the scroll button and press enter to confirm the unit
selection
•
If there is a temperature and humidity sensor attached there is the option to choose from
either °C or °F
3.4.2. Max/Min/Average Measurement Cycle
•
To enter, scroll down in the set up menu and select “MAX MIN AV”
•
Select “start” to initiate the measurement cycle and return to the setup menu
•
Scroll to “EXIT” to return to the main display
•
The readings will scroll along the screen
Note: Only three parameters will be shown on the screen at one time.
•
In the Model 2750 the “MAX MIN AV” cycle can also be initiated from the main display by
holding down the “scroll down” button for 2 seconds until the unit beeps. Hold down the “scroll
down” button again for 2 seconds to stop the measurement cycle.
•
When the “MAX MIN AV” cycle is initiated, the display should read as seen below:
or
EXIT
LOCATION ID
MAX MIN AV
CALIBRATE
MONITOR SETUP
LOGGING SETUP
EXIT
ZERO CAL
UNITS
MIN MAX AV
MUTE KEY
O3 UL
PPM
RD 0.010
MIN 0.005
MAX 0.024
AVE 0.015
O3 UL TEMP RH
PPM
C %
RD
0.010
23 50
MIN
0.005
22 50
MAX
0.024
25 56
AVE
0.015
24 54
EXIT
MONITOR ID
UNITS
OUTPUT SENSOR
ALARM POINTS
CONTROL POINTS
MUTE KEY
CLOCK SETUP
Page | 10
Kanomax Gasmaster User Guide
MRK-D-0002 V3
