Component Maintenance Manual
P/N S185X501-XX
© KANNAD 2011
25-63-06
Page 7006
JUN 16/2011
SUBTASK 25-63-06-430-002-A01
(2)
Installation of front panel assembly (1-210)
Refer to Figure 7003 / 25-63-06-991-703-A01
(a)
Connect the connector of the battery pack (1-120) to the electronic PCB of the front panel
assembly (1-210).
(b)
Insert the front panel assembly (1-210) into the slides of the housing (1-200) and slide it into
the housing
taking care not to pinch the wires of the battery pack
.
(c)
For AP and AP-H versions install the mounting (1-90) used to attach the antenna and
lanyard. The antenna and lanyard must already be attached when installing the mounting.
NOTE:
The antenna thread (1-50) must be on the BNC antenna connector side, the
lanyard (1-30) must on the DIN12 connector side (
Refer to Figure 10001 / 25-63-
).
(d)
Screw the front panel assembly (1-210) to the housing (1-200) with the 4 screws (1-170)
and nuts (1-180).
Torque to 1 newton.meter ± 0.06 (8.85 pound-force inch ± 0.53)
.
NOTE:
For AP and AP-H versions, use the 2 screws (1-171) to fix the upper part of the
front panel assembly.
(e)
Affix a new seal label (1-150) onto the upper side of the front panel assembly and the
housing.
Figure 7004 / 25-63-06-991-704-1
FRONT PANEL ASSEMBLY, INSTALLATION
The document reference is online, please check the correspondence between the online documentation and the printed version.
