Component Maintenance Manual
P/N S185X501-XX
© KANNAD 2011
25-63-06
Page 7004
JUN 16/2011
(b)
Protecting the battery pack
NOTE:
A foam (1-160) is supplied with the battery kit (1-100). This foam, composed of
four leaves attached together and covered by adhesive , is used to protect the
battery pack when installed in the housing. This foam must be stuck around the
battery pack (1-120) .
1
Remove the adhesive from the foam.
2
Position the foam as to put the wire of the battery through the rectangular notch of the
foam.
3
Fold and stick the first leaf of the foam (at the right of the notch) on the right side of the
battery pack.
4
Stick the second leaf of the foam onto the front of the battery pack.
5
Fold and stick the third part of the foam onto the left part of the battery pack.
6
Fold and stick the fourth part of the foam onto the rear of the battery pack.
This leaf must also cover the end of the first leaf on the right side of the battery pack.
Figure 7002 / 25-63-06-991-702-1
PROTECTING THE BATTERY PACK
The document reference is online, please check the correspondence between the online documentation and the printed version.
