Kannad AF INTEGRA, Руководство по эксплуатации

Страница: 41 / 52

OPERATION MANUAL
AF INTEGRA / AF-H INTEGRA ELT
PAGE: 303
JUN 20/2013
FF FE 2F 96 E3 AF 0F 0F 7F DF FF 62 60 B7 83 E0 F6 6C
Example of same message decoded by Cospas-Sarsat Decoder:
FF FE D0 96 E3 AF 0F 0F 7F DF FF 62 60 B7 83 E0 F6 6C
NOTE: for location protocol beacons, the content of the encoded position data
field of the self-test message shall be the default values (extract from C/S T001
Cospas Sarsat.
(2) 121.5 MHz Transmission tests
This test must be carried out with a VHF receiver either with the aircraft VHF
receiver or with a not on-board VHF receiver.
IMPORTANT: Aircraft VHF receiver may be used only if 406 MHz test was
carried out with a Cospas-Sarsat decoder, otherwise check 121.5 MHz
using a VHF receiver (not the on-board VHF receiver) several dozens
meters away from the antenna. This ensures to validate the antenna.
• Tune VHF receiver to 121.5 MHz;
• Start transmission:
- Switch ELT to ON.
• Only 2 "sweep tones" are heard after 5 seconds, then the 121.5 MHz
stops.
• Stop transmission:
- Switch to OFF;
- continue to listen to 121.5 MHz for a few seconds to ensure that the ELT
does not continue to transmit after the test is terminated.
IMPORTANT: If the ELT operates for approximately 50 seconds, a 406
MHz signal is transmitted and is considered valid by the satellite system.
Switch ELT to ARM.
This check shall only be conducted during the first five minutes of any UTC,
(co-ordinated universal time) hour, and restricted in duration to not more than
five seconds. Be sure to notify any nearby control tower of your intentions.