Install the lower bracket 2 ¾- inches
in front of the tail wheel bracket.
Install the lower flying wires, they
should be just tight enough to have no
endplay but not distort the stabilizer.
Once adjusted, tighten the lock nut
and install the rubber keeper. Repeat
the process for the upper wires.
Because right thrust is built into the
firewall it is necessary to mount the
engine 3/8-inch to the left of the
firewall centerline. This will insure the
prop/spinner is in the center of the
cowl hole. The vertical center will be 2
¼-inches up from the bottom of the
engine box.
The distance from the firewall to the
propeller flange or spinner must be
between 6 7/8-inches and 7 1/4-inches.
6 7/8 to 7 1/4-inches
2 ¾-inches
Assemble the fuel tank with the
proper stopper for your fuel type. The
proto-type uses a three-line system
with two vents out the bottom; this
will only work with gas. Check your
engine manufactures instructions for
the required fuel line system.
Install the throttle servo and the
supplied nylon push rod. Follow the
radio manufactures instructions for
mounting the servo. Be sure the servo
operates in the proper direction. Cut
and fit the push rod to the engine.
2 ¼-inches
center line
3/8-inch
6
