The control components supplied with this
aircraft have been thoroughly tested and
work well, however we also understand that
all modelers have their own preferences for
control systems. We hope you will find the
supplied components easily adaptable to
your personal standards
To avoid damage to the servos or airframe,
be sure all servos are centered and the servo
arms are installed correctly before installing
the control rods.
With a razor cut the covering down the
center of the two slots each side of the rear
of the fuselage. They can easily be found by
shining a flashlight down the inside of the
fuselage.
Mount the servo tray inside the fuselage with
the four screws.
Install the rudder servo from the bottom
with the appropriate pull-pull horn for your
servo. The horn should approximately 2 1/2-
inches wide.
Shown below is the method used to fabricate
the pull-pull wires. Pass the cable through
the coupler; loop it through the end link
then back through the coupler. Crimp the
center of the coupler and add a drop of CA.
Install the rudder cables. Some modelers
like to cross the cables in the fuselage some
do not, It’s up to you. Use the knurl nut to
lock the clevis in place.
9
