ASSEMBLY
Because the tail section is removable, the flying
wires are functional. Locate the pre-drilled
holes in the fin and stabilizer for the flying
wires attach brackets. The holes are small and
difficult to find. They must be opened with a
pin.
Use the rudderpost to locate the alignment
holes in the rear of the fuselage. Open the
holes.
Assemble the tail as shown with a piece of
waxed paper between the stabilizer and the
rudder support block. Install the stabilizer
hold down screws for alignment, do not tighten
Use a felt tip marker to outline the rudder
support block on the side of the fin.
With a sharp hobby blade and a straight edge,
slice the covering ¼ inch below the marked
line. Be careful not to slice into the wood, as
that would weaken the structure. Peel away
the covering a shown.
Apply a
thin
coat of epoxy to the inside of the
rudder support block. The waxed paper will
prevent it from sticking to the stabilizer. Slide
the rudder all the way in, engaging the
rudderpost alignment pins. Wipe away the
excess epoxy with a paper towel moistened
with alcohol. Allow to cure before moving.
