
25
24
My Kangaroo Model 5 Stopped Running.
Did the motorcaddie die gradually as the round of golf progressed?
When the motorcaddie starts out with enough power and slowly diminishes toward the end of the round, it’s
probably your battery. If your battery is over a year old and fully charged, you may need to order a new bat-
tery. If you have doubts that your battery is the problem, try borrowing or swapping batteries with a friend.
My battery seems okay, but the motorcaddie was a little sluggish in the begin-
ning of play then died during my round of golf.
Did the motorcaddie seem to be struggling on inclines? If so, reach down and touch the motor. If the motor is
HOT to the touch, then your motor will need to be serviced or replaced. It is normal for the motor to be warm
to the touch, but it should never get
HOT
to the touch.
Did the motorcaddie just stop all of a sudden during the round of golf?
First, review Controls operation in this manual (pages 7, 8). Check your battery wire clips. While standing be-
hind the motorcaddie, wiggle them to see if the motorcaddie will power up while moving the wires. If it does,
then you have a broken wire somewhere on your battery clips. To check your battery wires, open the crocodile
clips and clip them on to an object 3/4” thick so they are held in the open position. Then slide the black/red rub-
ber covers back to inspect the metal clip, solder joint and wire.
My motorcaddie stops and starts intermittently!
Check the plug on the control wire and the receptacle on the chassis. Make sure they are clean of any
debris and that they are dry. Use “canned air” like the type used on computer keyboards to carefully blow
out both the handle plug and the control receptacle.
My Upper Bag Support keeps falling down.
Is your yoke-stop broken? If so, you will need to order a new yoke stop. If your yoke stop isn’t broken, check
the screw to make sure it’s tight. If the screw is broken off in the yoke, the fragment of the screw will have to
be removed using an easy-out tool, or a new yoke will need to be purchased.
Upper Tube
Yoke Stop Metal
(400-421A)
Yoke Stop Boot
(400-499)
Yoke Stop Screw
(899-830B)
Lock-Nut
(899-492)
Yoke Friction Washer
(400-416A)
Yoke
Assembly
(400-490)
1/4”x 20 x 1 1/4 Bolt
(899-490)
Yoke Clamps
Top (407-414)
Bottom (407-413)
Includes all
Parts Shown
Here
Why does my charger never shows GREEN (Schauer Smart Charger) or
double GREEN (ReadyPRO Smart Charger)?
The battery (BATPA) is incapable of being fully charged. It should be replaced.