BEFORE STARTING
6
STARTING TO WORK
7
CHECK THE FUEL LEVEL
1. Remove the fuel tank cap and check the fuel level.
2. Add fuel to the filter level if necessary.
3. Screw the fuel tank cap back tightly.
CHECK THE OIL LEVEL
Generstor is transported without the motor oil. Please don’t start the engine
without filling the sufficient amount of motor oil.
Recommended fuel:
Unleaded gasoline
Fuel tank volume
: see specifications table.
Ensure that the power tool or consumers meet
current capabilities of the generator
before starting the
engine. It is prohibited to exceed its rated capacity.
Do not connect the device before starting the engine!
Do not tilt the generator when adding engine oil. This could result in over filling and damage to the engine. The
generator can be used with the rated output load at standard atmospheric conditions.
The output of the generator varies due to temperature change, altitude (lower air pressure at higher altitude) and
humidity. The output of the generator is reduced when the temperature, the humidity and the altitude are higher
than standard atmospheric conditions. Additionally, the load must be reduced when using in a confined area, as
generator cooling is affected.
Recommended engine oil:
SAE 10W-30, SAE 10W-40.
Recommended engine oil grade:
API Service SE type or higher.
Motor oil quantity:
see specifications table.
1. Unscrew the oil dipstick and wipe it out with a clean cloth.
2. Insert the dipstick without screwing it in.
3. Check the oil level by a mark on the oil dipstick.
4. Add oil if its level is below the mark on the oil dipstick.
5. Screw on the dipstick.
Immediately wipe off spilled fuel with a clean, dry, soft cloth,
since fuel may deteriorate painted surfaces or plastic parts. Use
only unleaded gasoline. The use of leaded gasoline will cause
severe damage to internal engine parts.
IMPORTANT!
Do not change the configuration of the amount of fuel or speed
controllers (this adjustment was made before the sale). Otherwise,
there will be possible changes in the engine work or breakage.
IMPORTANT!
Standard atmospheric conditions
Ambient temperature: -5
о
С to +30
о
С
Barometric pressure: 100 kPa
Relative humidity: less than 70%
Do not let the generator work more than 30 minutes in range from
nominal to maximum.
ATTENTION - DANGER!
fill to here
www.ks-power.de/en
|
22
