8
Kamstrup A/S • 5512603_C1_GB_03.2016
MULTICAL® 801
2.2
Pocket sensors
The sensor pockets can be
mounted in e.g. a welding sleeve
or in a 45° lateral Y-piece. The tip
of the sensor pocket must at least
reach the center of the flow pipe.
Push the temperature sensors
as deep as possible into the
pockets. If a short response time is
required, “nonhardening” thermally
conductive paste can be used. Push
the plastic sleeve on the sensor
cable into the sensor pocket and
secure the cable by means of the
enclosed M4 sealing screw. Fasten
the screw with your fingers only.
Seal the pockets using seal and
locking wire.
3 Mounting of flow sensor
Prior to installation of the flow sensor, the system should be flushed and
protection plugs/plastic diaphragms removed from the flow sensor.
Correct flow sensor position (inlet or outlet pipe) appears from the front label
of the MULTICAL® 801. The flow direction is indicated by an arrow on the flow
sensor.
