5. Operation Controls and Functions
5.1 Front Panel
4
Number
Name
Function descriptions
1
OLED display Display system input/output port status, EDID
management and matrix IP address.
2
IR Window
3
IR receiver window, it receives IR remote control
signal to control this device.
1
2
3
4
Left/Right/Up/
Down/Menu
Buttons
After system power up, the OLED screen default displays
the input and output status of the last power off.
A) On the initial OLED display, you can press the
‘Left’ or ‘Right’ button firstly to select output port,
then press the ‘up’ or ‘down’ button to select the input
port, then press the ‘MENU’ button to confirm this
operation.
B) On the initial OLED display, you can press the ‘Up’
or ‘Down’ button to check each input EDID setting,
press the ‘Menu’ button go back to the initial
OLED display.
C) On the initial OLED display, you can press ‘Menu’
button to operate the following functions by the
combination of these five buttons, press ‘Up’ or
‘Down’ button to select function:
1. Select EDID: Press the ‘Right’ button, then press
the ‘Up’ or ‘Down’ button to select EDID as showed in
the below table. Once you complete EDID selection,
press the ‘Right’ button then press the ‘Left’ or ‘Right’
button to select your EDID to copy to which
input port, press the ‘Right’ button to confirm this
operation.
2. PTP Set: Press the ‘Right’ button to set PTP mode
(point to point, means IN1-OUT A, IN2-OUT B, IN3-
OUT C...).
3/19
