Operating Mode
When the laser is powered on, the LCD monitor on rear panel shows the current operating standalone mode, DMX address or
Slave mode. With help of the LCD control panel, it is very easy to set and change the operating mode of the laser. The next time
the laser is powered on it will show the last setting used before the laser was powered off.
Mode Option, to choose the operating mode of laser.
Confirmation, to confirm the selected mode.
UP/DOWN, to change operating mode, parameter or DMX address.
Operation
Display
Stand alone mode pre-programmed effect
AUT
Automatically cycle through its built in programs. This mode will only show the “in air” effects.
A3d
Automatically cycle through the built-in 3D effects
AUB
Automatically cycle through the built-in traditional beam effects.
AUL
Automatically cycle through the built-in northern lights effects.
AUN
Automatically cycle through the built-in gratings effects.
AUO
Automatically cycle through the built-in 3D universe effects.
SUT
Cycle through its built in programs by sound activation. This mode will only show the “in air” effects.
S3d
Cycle through the built-in 3D effects by sound activation
SUB
Cycle through the built-in traditional beam effects by sound activation
SUL
Cycle through the built-in northern lights effects by sound activation
SUN
Cycle through the built-in gratings effects by sound activation
SUO
Cycle through the built-in 3D universe effects by sound activation
