Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
8
TKG DAT 1000 - 121017
Assembly page 8/36
Fax +32 2 359 95 50
FILLING THE WATER TANK
You can use demineralised water or tap water. If you use tap water, make sure you descale
the appliance regularly according to the amount of scale the water contains. If you want to
use the steam jet button, fill the water tank as follows:
1)
Unplug the iron from the outlet to let it cool down and set it horizontally on a stable level
surface.
2)
Turn the temperature dial to
"MIN".
3)
To fill the water tank, pour water through the fill opening using a measuring cup. Do not
overfill the water tank.
4)
When ironing, unplug the appliance before refilling. Fill the water tank by holding the
appliance in horizontal position without putting down the hot sole plate, unless you have a
heat-resistant base.
TEMPERATURE SETTINGS
•
You can choose the temperature setting according to the cloth that needs to be ironed.
•
In order to turn the iron on, please turn the temperature knob clockwise into the required
position (see table below). In case of doubt, take a look at the garment label.
IRONING
Kind of textile
Temperature dial
Nylon
Synthetic
(e.g. acetate,
acrylic, viscose, polyamide,
polyester, …)
MIN
|
|
Silk
Wool
|
|
Cotton
Linen
|
|
MAX
•
Fill the water tank.
•
Plug in the appliance.
•
Turn the temperature dial clockwise into the required position.
•
Set the iron on its heel and wait until the temperature indicator goes out.
BURST OF STEAM
The burst of steam feature provides steam to remove stubborn creases.
To generate steam, you have to pump (press-release-press-release…) the steam jet button. No
steam comes out during the first 5 to 6 presses because the water needs to get to the
soleplate.
Caution
: Set the temperature dial within the steam range ('
' or '
'). If the temperature
setting is too low, water may drip from the soleplate.
Check the garment label before ironing because some cloths may be damaged when
exposed to steam or water.
