INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1147083-2-
B
6 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
5. COMPLETE THE INSTALLATION
If desired, apply a bead of caulk or silicone sealant where the marble console top meets the wall.
Install the p-trap according to the manufacturer’s instructions.
Connect the water supply and check all connections for leaks. Repair as needed. Re-install the adjustable
shelf in the desired location.
If door operation is not smooth, lubricate the hinges with a small amount of oil. Take care not to get the oil
on the wood.
surfaces.
the dlocation.desired location
.
6. REMOVE/ADJUST THE DRAWERS
Drawer Height
Adjustment Wheel
Release Latch
Underside View
Rail
Tab
NOTE:
A drawer height adjustment wheel and release latch are located underneath the front of the drawer at
each corner.
To remove the drawer:
Slide the drawer out on the rails until fully extended.
Pull both release latches toward you, then pull the front of the drawer up off the rails.
Lift the drawer out from the vanity.
To reinstall the drawer:
Fully extend the rails
and
a
lign the grooves on the underside of the drawer with the rails and set into place.
Hold the drawer in place on the rails with one hand. With your other hand, pull the tab on the bottom front of
the rail toward you until you hear the rail
″
snap
″
into place. Repeat this step for the remaining rail.
Ensure the drawer is locked into place by lightly lifting the front of the drawer upward. If the drawer does not
lift up, it is engaged. If the drawer lifts up, repeat the above procedure.
Adjustment:
Slide the drawer out on the rails until fully extended.
Turn the drawer height adjustment wheels to adjust the drawer height. To lower the drawer, turn the wheel
on the left side of the drawer clockwise and/or the wheel on the right side of the drawer counterclockwise.
Turn the wheel(s) in the opposite direction to raise the drawer.
