INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1147083-2-
B
4 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
2. TEST FIT THE VANITY AND MARBLE
Mark supply and drain locations.
Wooden Vanity Cabinet
Levelers
Remove the adjustable shelf from the wooden vanity cabinet.
Position the wooden vanity cabinet against the
fi
nished wall.
Verify the wooden vanity cabinet is level front to back and side to side. If necessary, adjust the levelers on
the bottom of the wooden vanity cabinet.
Mark the supply and drain locations on the inside of the wooden vanity cabinet back wall. Move the wooden
vanity cabinet away from the wall.
Cut the marked supply and drain locations from inside of the wooden vanity cabinet using a hole saw.
Position the wooden vanity cabinet against the wall, aligning the supply and drain locations with the cut
holes on the wooden vanity cabinet back wall.
3.
MARBLE TOP HOLE FABRICATION (OPTIONAL)
Three f aucet holes have been partially drilled from the underside of the console top.
On the top, show surface, of the console top, locate the center of the required faucet holes. Using a
compass or circle template, draw a circle for the required holes.
Using a small hammer, create the faucet hole(s) by gently tapping the console top within the circles until the
marble breaks away.
NOTE: DO NOT
strike the console top with too much force.
DO NOT
strike from the bottom side of the console
top. This will damage the top surface of the console top.
Using a
fi
le or sanding cylinder, complete the removal of marble material to create a clean round hole.
