INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1147083-2-
B
5 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
4.
INSTALL THE MARBLE TOP
Wooden Vanity
Cabinet
Stone Vanity Top
Apply clear 100%
silicone caulk or sealant.
NOTE:
If using a lavatory with over
fl
ow, ensure that the lavatory is installed with the over
fl
ow to the front of the
marble top and vanity.
Install the lavatory and faucet to the marble vanity top at this time. Refer to the lavatory and faucet
manufacturer’s instructions for instructions.
With the help of an assistant, place the marble vanity top on top of the wooden vanity cabinet. Verify correct
fi
t and alignment of all components. Adjust as necessary.
With the help of an assistant, carefully remove the marble vanity top and set aside.
Drill two pilot holes through the mounting rail and
fi
nished wall on each side of the wooden vanity cabinet.
Make sure the two pilot holes are spaced a minimum of 16
″
(406 mm) apart from one another.
Tighten a wood screw through each of the two drilled holes until the wooden vanity cabinet is
fl
ush and
secure against the
fi
nished wall.
Apply clear 100% silicone caulk or sealant to the top of the wooden vanity cabinet.
With the help of an assistant, replace the marble vanity top on top of the wooden vanity cabinet. Verify
correct
fi
t and alignment. Adjust as needed.
